Mportant, Nformation – Martin Fireplaces B36RA User Manual
Page 3
3
2
I
MPORTANT
I
NFORMATION
1.
Read these instructions entirely before beginning any part of the installation. Save these instructions for any
future repairs.
2.
Use these instructions as a guide during the installation of the fireplace.
3.
Be sure these instructions become the property of and are reviewed by all future users of this fireplace to
encourage proper operation and maintenance.
4.
All the parts used with this fireplace system must be installed in accordance with these installation instructions.
Failure to do so may be hazardous and will void the warranty.
5.
This fireplace and accessories should not be altered in any way that is not specifically recommended in this
manual.
6.
Refer to your local building code for local requirements pertaining to installation of factory-built fireplaces.
Martin Hearth & Heating fireplaces are intended for installation and use according to standard NFPA 211 of the
National Fire Protection Association.
7.
This fireplace must not be installed with a masonry flue.
8.
This fireplace and chimney should not be used for venting a wood or coal burning heater or fireplace insert.
WARNING:
DO
NOT
INSTALL
A
SEPARATE
SOLID
FUEL
INSERT
OR
GAS
FIREPLACE
INSERT
IN
THIS
FIREPLACE
AND
CHIMNEY
SYSTEM
WITHOUT
WRITTEN
AUTHORIZATION
FROM
M
ARTIN
H
EARTH
& H
EATING
.
9.
Do not pack required air spaces with combustible material or insulation not specifically recommended for use
in such areas.
Intended Product Usage
This fireplace is intended for supplemental heating only and is not intended for use as a primary heatingsystem.
This fireplace is designed to sit directly on a combustible floor. The fireplace can be installed with zero clearances
to combustible building materials at the side, back and top spacers. Only parts manufactured by Martin Hearth &
Heating and labeled for use with this fireplace should be used in the installation of the fireplace except for special roof
flashings that may be fabricated locally. The use of improper parts in the installation can be hazardous and voids the
warranty offered by Martin Hearth & Heating.
This fireplace is designed to burn solid wood fuel (wood).This fireplace is not designed to burn coal, unplumbed liquid
fuels, unplumbed gaseous fuels or household refuse. Any attempt to burn these fuels in the fireplace can be hazard-
ous.
This fireplace is designed for installation in mobile homes if it is installed in accordance with figure 32 in this manual,
which includes using an OAC6 combustion air assembly, WB36LR glass door, SVT firestop thimble, and use either the
LLK or RLK louver kit.
WARNING: DO NOT INSTALL IN A SLEEPING ROOM OF A MOBILE HOME.
CAUTION: I
F
INSTALLED
IN
A
MOBILE
HOME
,
THE
STRUCTURAL
INTEGRITY
OF
THE
FLOOR
,
WALL
AND
CEILING
/
ROOF
MUST
BE
MAINTAINED
.
WARNING: T
HIS
FIREPLACE
AND
CHIMNEY
MUST
NOT
BE
USED
FOR
VENTING
A
SOLID
FUEL
HEATER
OR
FIREPLACE
INSERT
UNLESS
WRITTEN
AUTORIZATION
IS
GIVEN
BY
M
ARTIN
H
EARTH
& H
EATING
. F
AILURE
TO
HEED
THIS
WARNING
MAY
CAUSE
FIRE
HAZARD
AND
WILL
VOID
THE
WARRANTY
.
improper installation or use of this fireplace will void its warranty and can cause:
1. Damage to the fireplace from overheating.
2. Hazardous temperatures to develop on combustible materials adjacent to the fireplace or chimney.
3. The emission of smoke, sparks or hazardous gases into the dwelling.
4. Leakage of rain water into the dwelling.
53D9041. Rev 1 03/03