English – Motorola NETOPIA 2247/57-62 User Manual

Page 18

Advertising
background image

18

ENGLISH

If a status indicator light does not look correct, look for these possible problems:

If LED is

not Lit

Possible problems

Power

•

Make sure the power switch is in the ON position.

•

Make sure the power adapter is plugged into the DSL Gateway properly.

•

Try a known good wall outlet.

•

Replace the power supply and/or unit.

DSL

•

Make sure that any telephone has a microfilter installed.

•

Make sure that you are using the correct cable. The DSL cable is the thinner standard tele-
phone cable.

•

Make sure the DSL cable is plugged into the correct wall jack.

•

Make sure the DSL cable is plugged into the DSL port on the DSL Gateway.

•

Make sure the DSL line has been activated at the central office DSLAM.

•

Make sure the DSL Gateway is not plugged into a micro filter.

Ethernet

1,2,3,4

•

Make sure you are using the Ethernet cable, not the DSL cable. The Ethernet cable is thicker
than the standard telephone cable.

•

Make sure the Ethernet cable is securely plugged into the Ethernet jack on the PC.

•

Make sure the Ethernet cable is securely plugged into the Ethernet port on the DSL Gate-
way.

•

Try another Ethernet cable if you have one available.

•

Make sure you have Ethernet drivers installed on the PC.

•

Make sure the PC’s TCP/IP Properties for the Ethernet Network Control Panel is set to obtain
an IP address via DHCP.

•

Make sure the PC has obtained an address in the 192.168.1.x range. (You may have
changed the subnet addressing.)

•

Make sure the PC is configured to access the Internet over a LAN.

•

Disable any installed network devices (Ethernet, HomePNA, wireless) that are not being
used to connect to the DSL Gateway.

Advertising