English, Surround mode, Channel level control – Marantz SR8000 User Manual
Page 17: Multi room setup
13
ENGLISH
SURROUND MODE
SOURCE DIRECT :
Switch the source direct ON or OFF with or
button. This bypasses the surround processing
and crossover for the main speakers (front left
and right will be full range and the subwoofer will
be ON)
Note:
Surround mode cannot be changed in
Source Direct mode.
SURR-MODE :
Select the surround mode with or button.
NIGHT MODE :
Switch the NIGHT MODE ON or OFF with or
button.
Selecting the Night Mode ON is effective in
Dolby Digital only, and it compresses the
dynamic range.
This softens loud passages such as sudden
explosions, to help prevent disturbing others late
at night.
LFE LEVEL :
Select the output level of the LFE signal included
in the Dolby Digital signal or the DTS signal.
Select 0dB, -10 dB or OFF with or button.
The level is ordinarily set to 0 dB except DTS-
Music mode. In the DTS-Music mode, default
level is set to -10 dB.
HT-EQ:
Switch the HT (Home Theater) - EQ on or off with
or button.
This mode compensates for the audio portion of
a movie sounding “bright”.
This equalizer is effective in AUTO, DOLBY,
DTS-cinema, DTS-music and STEREO mode.
CHANNEL LEVEL CONTROL
Desired channels can be selected by pressing , or
CH+
, button.
Each channel level will be adjusted by pressing , ,
LVL+
, or
LVL–
button.
Only the usable channels which are determined depending on the
SURROUND mode, and SPEAKER SETTING are displayed.
MULTI ROOM SETUP
MULTI ROOM :
To switch on the Multi-room output.
VIDEO :
Select the video source of the Multi-room
output.
AUDIO :
Select the audio source of the Multi-room
output.
VOLUME :
Select whether the Multi-room output level
is variable or fixed.
VOLUME LEVEL :
Adjust the Multi-room output level.
MAIN ROOM STATUS :
Selected input source in the main room will
be displayed.
Notes:
If “VOLUME” is set to “FIXED”, the multi-room output level cannot
be adjusted.
You cannot transmit a digital signal using the multi-room function.
Any source component that is desired to be operated in the
second zone needs to have the analog outputs connected to
receiver.