Mellerware 3 3 0 0 1 - Manual (Page 3)

HOW TO OPERATE YOUR KETTLE
It is important that you read these instructions
before using your kettle for the first time.
1. Open the lid of the kettle by pulling the lid
trigger, fill with tap water to the desired level.
(Min. capacity is 0.5L and max. capacity is 1.0L).
In hard water areas, using purified or filtered
water is recommended to reduce the amount of
scale build up in the kettle.
2. Close the lid by releasing the lid trigger. Place
the kettle on the base and plug into the mains.
3. To switch on the kettle, press the On/Off switch
up (position 1). The power indicator light will
now be on. When the water has boiled the
kettle will automatically switch off. You can stop
the kettle at any time by pressing the On/Off
switch down (position 0).
4. Pour slowly and carefully. If you wish to re-boil,
please allow a few minutes for the kettle to cool
down.
WARNING: If the kettle has just boiled it will
be full of steam that will escape if the lid is
opened.
IMPORTANT: Do not open the lid when steam
is coming out of the spout. Before pouring or
filling always remember to disconnect from
electricity.
Note: If the kettle is switched on when empty or
with insufficient water, then the kettle will switch
off automatically to protect against dry boiling.
Wait until the heating element cools down,
refill with tap water and use as normal. This
protection function is not designed for regular
use, as it will shorten the life of the kettle.
If the kettle is overfilled, boiling water may be
ejected.
The kettle is only to be used with the stand/base
provided.
The appliance must not be immersed during
cleaning.
If the supply cord is damaged, the manufacturer
or its service agent or a similarly qualified person
must replace it in order to avoid a hazard.
INSTRUCTIONS FOR USE:
1. Flip Top Lid
2. Lid Trigger
3. Handle
4. On/Off Switch
5. Stand/Base
6. Water Level Indicator
7. Body
8. Spout
1
8
6
7
2
3
4
5