Maytag HRX40HARS - Manual (Page 6)

6
ACCESSORIES AND TOOLS NEEDED
Accessories
To simplify the installation Maytag has available the installation parts shown below. You may or may not need all of these accessories
depending on your type of installation. Call a Maytag Service Specialist at 1-800-365-0024 for an authorized installer.
EXPANSION TANKS FOR THERMAL EXPANSION CONDITIONS
AVAILABLE IN 2 GALLON (7.6 LITERS), Part No. 9850048 AND
5 GALLON (18.9 LITERS), Part No. 9850049 CAPACITY. DRAIN PANS AVAILABLE IN 22” (559 mm) DIAMETER (PART
NO. 9001609) FOR WATER HEATERS HAVING A DIAMETER 20”
(508 mm) OR LESS, 24” (610mm) DIAMETER (PART NO. 9002769)
FOR WATER HEATERS HAVING A DIAMETER 22” (559 mm) OR LESS
AND 28” (711 mm) DIAMETER (PART NO. 9001608) FOR WATER
HEATERS HAVING A DIAMETER 26” (660 mm) OR LESS.
Tools
You may or may not need all these tools, depending on your
type of installation. These tools can be purchased at your local
hardware store.
• Pipe Wrenches (2) 14” (356 mm)
• Screwdriver
• Tin Snips
• 6’ (1.82 m) Tape or Folding Ruler
• Garden Hose
• Drill
• Pipe Dope or Teflon Tape
Additional Tools Needed
When Sweat Soldering
• Tubing Cutters or Hacksaw
• Propane Tank
• Soft Solder
• Solder Flux
• Emery Cloth
• Wire Brushes
SLOT-HEAD SCREWDRIVER
PHILLIPS SCREWDRIVER
TIN SNIPS
PIPE WRENCH
PIPE DOPE
(SQUEEZE TUBE)
USE FOR WATER AND GAS
CONNECTIONS
DRILL
GARDEN HOSE 6 FOOT TAPE
ROLL OF TEFLON
TAPE (USE ONLY ON
WATER HEATER
CONNECTIONS)
HACKSAW
3/4” (19 mm) WIRE BRUSH
1/2” (13 mm) WIRE BRUSH
SOLDER
FLUX
ROLL OF LEAD-FREE
SOFT SOLDER
TUBING CUTTER
PROPANE
TORCH
ROLL OF
EMERY CLOTH