Power sources – Memorex MD6483 User Manual

Page 6

Advertising
background image

5

This CD player requires either two (2) “AA” batteries (not included) or an
AC adapter (not included).

BATTERY INSTALLATION
The battery indicator (

) will blink in the CD display when the batteries

are low and need replacing.

1. Open the battery compartment door by

pressing out and then lifting up.

To prevent

the possibility of losing the cover, it
cannot be removed.

2. Insert two (2) “AA” batteries (not included)

according to the polarity diagram inside the
battery compartment. Alkaline batteries are
recommended for the longest playing time.

AC OPERATION
To operate the unit using AC power, connect an AC adapter (not
included) to an AC outlet having 120V, 60Hz AC only. Plug the small end
into the DC 4.5V jack on the rear of the unit and connect the other end
into an AC outlet. The batteries are automatically disconnected when an
AC adapter is used.
CAUTION: When not using AC power, disconnect the AC adapter from
the wall outlet by pulling the plug (not the cord). Do not touch the AC
adapter with wet hands. Fully insert the plug without exposing any part of
the blade.

DC 4.5V –

+

POWER SOURCES

BATTERY PRECAUTIONS

Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated next to the battery

compartment. Reversed batteries may cause damage to the device.

3. Do not mix different types of batteries together (e.g. Alkaline, Carbon-zinc or Rechargeable) or old

batteries with fresh ones.

4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or

injury from possible battery leakage.

5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.

(Follow battery manufacturer’s directions.)

+

+

Advertising