Magic Chef MCBC580DBT - Manual (Page 4)

.
.
.
sunlight, heat or moisture.
.
.
This unit is not designed for use in garage or any
other outside installation.
.
.
Note: If you want to change door swing, change it
.
3
Installation
swing and access to the pull-out racks when installed
as a built-in.
The appliance can be installed freestanding.
Adjustable Feet
Some appliances have adjustable feet on the front
side; use them to level the appliance.
BUILT-IN INSTALLATION
The cutout dimensions shown allows for a full door
If installing between frameless cabinets, a 1/2" wide
Allow sufficient space for door swing.
filler strip or side panel may be needed on hinge
The cutout depth must be 24".
FREE STANDING INSTALLATION
Choose the location
Be sure the front of the appliance is unobstructed
for air circulation and proper access to the door.
side. The filler strip will act as a spacer between the
the surrounding cabinets.
Additional Specifications
The width of the opening must include the filler
panels. Note: The door should protrude 1" beyond
appliance case and adjacent cabinet door swing.
A 120 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install a
properly grounded 3-prong electrical receptacle
recessed into the back wall as shown. Electrical must
be located on rear wall as shown. Note: GFI (ground
fault interrupter) is not recommended.
Consult a qualified electrician or serviceman if the
wiring instruction are not clearly understood, or if
doubt exists as to whether the appliance is properly
grounded.
before installation.
Do not install the appliance where the temperature
will go below 55°F or above 90°F.
Do not install where it will be subject to direct