Moen 7025 - Manual (Page 4)

WATER FILTRATION SAFEGUARDS
Your PureTouch
®
Classic Filtering Faucet System integrates carbon block
filtration technology designed by Culligan ® International into a faucet
spout. This technology is fast and effective at reducing contaminants
commonly found in water and is certified by NSF
® International. The
PureTouch Filtering Faucet System and installation must comply with
State and Local laws and regulations. To ensure optimal operation of
your new Moen faucet, please read the following safeguards carefully.
MicroTech™ Filter Cartridges
• MicroTech filter cartridges will reduce :
Chlorine, Taste and Odor (MicroTech 400, 600)
Lead (MicroTech 400, 600)
Cysts (Cryptosporidium, Giardia)(MicroTech 600)*
* The contaminants removed or reduced by this filter are not necessarily in your water.
• Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
Systems certified for cyst reduction may be used on disinfected waters
that may contain filterable cysts.
• MicroTech filter cartridges are designed for replacement after
dispensing 200 gallons of filtered water. Water conditions and usage
may affect filter life and water taste.
• The electronic indicator will signal when filter replacement is necessary
(see page 9).
• Use only MicroTech 400 or 600 filter cartridges with the PureTouch
Classic Filtering Faucet System.
• Filter flow rate = .4-.6 gpm at rated pressure (20psi min. - 125psi max.).
Water Temperature
• Minimum/Maximum faucet operating temperature = 40° - 150°F.
•
CAUTION: Do not filter water above 100° F.
MicroTech Filter Flushing Instructions
• New MicroTech Filter Cartridge: After installing a new filter into the
faucet, allow cold water to run through the filtered water outlet for 5
minutes to flush out any loose carbon particles. The filter life
indicator will alternately flash amber and green for the first five
minutes after the indicator is manually reset (see page 9) as an aid
in timing the filter flushing period.
• Daily Use: Allow cold water to run through the filter for 10-15
seconds prior to first use. If the filter has not been used for several
days, run cold water through the filter for 60 seconds prior to use.
Questions
• If you have any questions please call our toll-free helpline,
1-877-DRINK-H2O. Monday through Friday 8:00 a.m. to 8:00 p.m.
1-877-(374-6542) Saturday 8:00 a.m. to 6:30 p.m.
3 HELPLINE: 1-877-DRINK-H2O
1-877-(374-6542)
INS215A