Miele G 7827 - Manual (Page 42)

Water connection
This machine must be connected to
the water supply in accordance with
all national and local plumbing
codes.
,
Water in the machine is not
suitable for drinking.
The washer is constructed so that it
may be connected to a water supply
without an extra non-return valve,
unless required by code.
Faucets and drain connections should
be situated as close to the machine as
possible, and be easily accessible.
Water supply pressure
Hot + Cold water connection =
min. 22 psi - max.145 psi
DI water connection =
min. 9 psi - max. 145 psi
Recommended water pressure
Hot + Cold water connection =
over 37 psi - max.145 psi
DI water connection =
over 22 psi - max. 145 psi
to avoid long intake times
The machine cannot be operated with
an inflow pressure of less than 10 psi.
The machine is supplied with
3 connection hoses 5 ft. (1.5 m) long
with
3 /
4
" (19 mm) female hose thread
ends.
Large area filters, supplied with the
machine, are to be installed in the hose
attached to the water supply. See
"Cleaning and Care - Cleaning the
water inlet filters".
,
Do not shorten or damage the
hoses!
Do not remove the filters in the
hoses.
Plumbing
42