Miele TOUCHTRONIC T 9820 - Manual (Page 16)

6. Program end - Unload the
laundry
The "Anti-crease/End" indicator will light
at the end of the program and the
buzzer will sound if it was selected.
The indicator of the reached drying
degree lights (depending on program).
To avoid wrinkles, the drum turns in
intervals for up to one hour, if the
laundry is not immediately removed
(Anti-crease).
^ Open the door.
If the door remains open, the light goes
off after a few minutes (saving energy).
^ Remove the laundry.
,
Check the drum for any missed
pieces of laundry. Any items left in
the dryer may be damaged because
of over drying.
^ Clean the lint filter after each use
(see "Dryer care").
,
Take care when inserting the lint
filter not to hurt your fingers.
^ Insert the lint filter with the yellow
handle edge towards the drum.
^ Close the door.
Changing a running program
A running program cannot be changed
(protection from accidental changes).
To select a different program the
running program must be canceled.
To cancel a program
^ Press the "Start/Stop" button.
The laundry will be cooled in case a
certain drying time and temperature
were reached.
If you press the "Start/Stop" button
again during the cooling phase, the
"Anti-crease/End" indicator lights.
^ Open and close the door.
^ Select the new program.
Adding/removing laundry
during a drying program
^ Open the door.
,
Do not touch the rear of the
drum while adding or removing
items! Danger of burns.
^ Add or remove items.
^ Close the door.
^ Press the "Start/Stop" button.
Use
16