Philips Magnavox 27MS4504 - Manual (Page 5)

B
ASIC
A
NTENNA
C
ONNECTIONS 1
A combination antenna receives normal
broadcast channels (VHF 2–13 and
UHF 14–69). Your connection is easy
because there is only one 75
Ω (ohm)
antenna plug on the back of your TV, and
that’s where the antenna goes.
1 If your antenna has a round
cable (75 ohm) on the end, then
you're ready to connect it to the
TV.
If your antenna has a flat,
twin-lead wire (300 ohm), you
first need to attach the antenna
wires to the screws on a 300- to
75-ohm adapter.
2 Push the round end of the
adapter (or antenna) onto the 75
Ω
(ohm) plug on the back of the TV.
If the round end of the antenna
wire is threaded, screw it down
finger tight.
ANT 75‰
L/Mono
Monitor out VIDEO
S-VIDEO
AV1 in Y Pb Pr
AV2 in
AUDIO R COMPONENT VIDEO INPUT
1
Back of TV
Cable signal
coming from
Cable Company
Jack Panel
Back of TV
75 ⍀
1
2
75‰ L/Mono
R S-VIDEO VIDEO
AUDIO
AV1 in Monitor out
COMPONENT VIDEO INPUT
Y Pb Pr
AV2 in
B
ASIC
C
ABLE
TV C
ONNECTIONS
T he Cable TV input into your home
may be a single (75 ohm) cable. If so,
this connection is very simple. Follow the
steps below to connect your cable signal
to your new television.
1 Connect the open end of the
round Cable Company sup-
plied cable to the 75
Ω input on
the TV. Screw it down finger tight.
Antenna Connection
300 to 75 Ω
Adapter
Combination
VHF/UHF Antenna
(Outdoor or Indoor)
Twin Lead
Wire
Round Cable
75 Ω
Back of TV
Direct Cable Connection
75 Ω Round
Coaxial Cable