Melissa ide line 745-190 - Manual (Page 9)


KEY TO MAIN COMPONENTS OF
THE APPLIANCE
1. Handle
2. Water reservoir
3. Funnel holder
4. Glass pot
5. Lid
6. Button for opening lid
7. Handle
8. Hotplate
9. Drip stop
10. Filter funnel
11. Handle with lock studs
12. Plastic filter (can be replaced by paper
filters)
13. On/off button
14. Power cord with plug
15. Water level gauge
16. Funnel lid
17. Measuring spoon (not visible on picture)
PRIOR TO FIRST USE
• Read through the safety instructions
carefully.
• Unroll the cord (14) fully before use.
• To rinse out the inside, fill the reservoir (2)
with water, switch on and allow the water to
run through the appliance before using it to
make coffee.
USE
1. Plug in and switch on at the wall.
2. Open funnel lid (16) using the handle (1).
3. Carefully pour the required amount of water
into the reservoir.
o Do not fill over the upper mark on the level
gauge (15).
4. Fit filter funnel (10) in the funnel holder (3),
and check it is correctly in place.
o Lift the funnel by the handle (11).
o Place funnel in its holder, and press firmly
into place. Check the flange on the back of
the funnel fits into the groove on the holder.
o Press the handle down and fold inwards
until the lock studs engage the holder on
both sides.
o Check the funnel is locked into place. If it is
not, the drip stop (9) may not work correctly.
5. Place the plastic filter (12) or paper filter (size
1 x 4) in the filter funnel, and put coffee in it.
6. Close the lid. If the lid cannot open fully, the
filter funnel is probably fitted into the holder
incorrectly. See item 4 above.
7. Ensure that the lid (5) for the glass pot (4) is
down and then place it on the hotplate (8)
beneath the filter funnel.
8. Switch on the appliance by switching the
on/off button (13) to "I". The on/off button
will light up (red) and the appliance will start.
o You can remove the glass pot during
brewing to pour a cup. The automatic drip
stop function ensures that coffee does not
drip from the filter onto the hotplate. As
soon as you replace the glass pot brewing
will resume. Always replace the pot within
30 seconds to prevent the filter funnel
overflowing.
o Always ensure the lid on the glass pot is
closed. If not, the drip stop may not work
correctly.
9. Once the coffee is ready, the hotplate under
the glass pot will keep it hot.
10. Switch off by pushing the on/off button to
the "0" position.
o The appliance is fitted with an overheating
cut-out which automatically switches it off if
you forget.
CLEANING
• Remove plug from the mains socket, and
allow the appliance to cool down before
cleaning it.
• The filter funnel plastic filter and glass pot
can be washed using normal washing-up
liquid, but are NOT dishwasher-safe.
o Remove the filter funnel by lifting the handle
up and pulling the funnel out of the holder.
o Replace as described under USE above.
• The best way to clean the appliance itself is
to wipe it with a well-wrung cloth using hot
water and a little detergent. The device must
not be submerged in any form of liquid.
• Do not use any kind of strong or abrasive
cleaning agent on the appliance or its
accessories. Never use a scouring sponge
or similar to clean it, as the surface may be
damaged.