Musical Fidelity M6500I - Manual (Page 12)

SPECIFICATIONS
Issue 2 Page 12 of 13
Output
Power 500 Watts per channel into 8 Ohms (27dBW)
Maximum output voltage 64 Volts RMS, 20Hz to 20 kHz; onset of clipping
(179 Volts peak-to-peak)
Maximum peak output current 100 Amps
Damping factor >250
Output devices 6 pairs per channel
Line input
THD+N <0.01% typical, 20Hz to 20 kHz
Signal / noise ratio >100dB ‘A’-weighted
Input impedance 38k Ohms
Frequency response +0, –0.1dB, 10Hz to 20 kHz
Connections
Line level inputs 1 pair line level XLR (balanced) connectors
4 pairs line level RCA connectors
Line level outputs 1 pair line level RCA connectors, constant level TAPE outputs
1 pair line level RCA connectors, preamp outputs for e.g. biamping
Speaker outputs 2 pairs heavy duty 4mm banana plug/binding posts per channel
Power requirement
Mains voltages 115/230VAC 50/60Hz (factory pre-set)
100VAC 50/60Hz (alternative)
Consumption 0.25 Watts standby (Orange LED lit)
150 Watts on, idle (Blue LED lit, no signal)
2000 Watts maximum (Blue LED lit, full power output)
Weight
Unit only, unboxed 28 kg (61 ⅔ lbs)
In shipping carton 33 kg (72 ⅔ lbs)
Dimensions
Width 440 mm (17 ⅓”)
Height (including feet) 160 mm (6 ⅓”)
Depth (front to back) including terminals 460 mm (18 ⅛”)
Standard accessories
IEC type mains lead (10-Amp type)
M6 500i remote control
Batteries, LR03 or AAA, manganese alkaline type - 2 off
Musical Fidelity reserves the right to make improvements which may result in
specification or feature changes without notice.