6installing antenna & batteries – MegaTech AfterBurner User Manual

Page 6

Advertising
background image

Remove the antenna from the slot on top

of the transmitter. Slide it into the hole

on top of the transmitter and turn clock

wise until snug. Do not over-tighten.

A. Be sure that both the transmitter and receiver switches are in the

“off” position.

B. Install 8 fresh “AA” alkaline dry

cell batteries in the transmitter

(see Figure 5) paying careful

attention to proper “+” and “-”

polarity. Turn the transmitter on to

make sure the LED light glows

green. Fresh batteries will provide

2 hours of power to the

transmitter. When the red LED

light glows, immediately install

Figure 5 - Transmitter Batteries

fresh batteries. Failure to do so will result

in loss of control and (most likely) a crash.

C. To install the receiver batteries, lift

up on the clasp and gently lift the

cover to the battery box. Then, lift

out the battery guard and the

battery case. Install 4 fresh “AA”

alkaline dry cell batteries and

carefully put everything back into

the battery box (see Figure 6).

D. Turn on the transmitter power switch, located

inside the door on the back of the transmitter

(see Figure 7). Next turn on the vehicle’s power

switch and listen for the servos to move slightly.

Move the steering control wheel and the throttle

trigger on the transmitter, making sure that the

steering control operates the front wheels and

Figure 4 - Install Antenna

Figure 6 - Vehicle Batteries

Figure 7 - Power Switch

6

Installing

Antenna & Batteries

Installing the Antenna

Installing the Batteries

Advertising