Marshall electronic V-R241-DLW - Manual (Page 22)

22
Use this setting to enable time code display on the screen. Time code is de-embedded from the vertical ancillary data
(VANC) within the HD/SDI signal. Two types of time code can be selected to display on the screen: LTC (linear time
code) or VITC (vertical interval time code).
The position of the time code display varies based on the aspect ratio setting and presence of IMD text.
■ Audio Monitor
Use the Audio Monitor menu option to enable or disable the audio presence indicator icon. When enabled, this icon
indicates whether embedded audio is present in the HD/SDI video input. A red circle and cross will flash on the icon if
no embedded audio is present.
■ CC Monitor (Closed Captioning)
Use the CC Monitor menu option to enable or disable the Closed Captioning presence indicator icon. When enabled,
this icon indicates the presence of 608 and/or 708 embedded Closed Captioning in the SDI video input. A green dot
indicates the presence of CC Data. A red dot indicates no captioning data.
■ OSD Timeout
Use the OSD Timeout setting to set the amount of time you would like to see the Menu on screen. Selectable values
range from 5 to 30 Seconds in 5 second increments. A value of None allows the menu to stay on screen until it is
manually exited.
Embedded Audio Present No Embedded Audio
No CC Data present
CC
608
708
Both 608 and 708 CC Data present
CC
608
708
00:00:00:00
Time Code display
Hours Minutes Seconds Frames