Manitowoc Ice K00067 - Manual

K00067 ICE BAGGER
Installation Instructions
ASSEMBLING BAGGER MOUNTING BRACKET
1. Remove the ice chute.
2. For left-handed users, assemble the bagger mounting
bracket on the left side, as illustrated in Figure A.
For right-handed users, assemble the bagger
mounting bracket on the right side of the bagger
cabinet, using the machine screws and lockwashers
provided.
TO USE ICE BAGGER
1. Hang bags on the rear bracket through the
rectangular slot in the bag hanger (see Figures B and
C).
2. Place supplied twist ties in front tray.
3. Replace the ice chute.
4. Pull open one bag under the ice chute.
5. Fill bag with ice, leaving enough room so the bag
can be twisted and closed.
6. Firmly pull bag of ice off of hanger, twist, and close
with twist tie.
REFILLING EMPTY BAG HANGER
1. Remove empty wire wicket from bag hanger and
discard.
2. Lay wicket of new bags down on a flat surface with
ends of wicket sticking straight up.
3. Slide the bag hanger down onto the wire wicket so
that the ends of the wire wicket go through the holes
in the bag hanger.
4. Tuck the top ends of the bags under the tab on the
front of the bag hanger.
5. Keep the bags and hanger lying flat. Use one hand
to compress the wire wicket, bags, and hanger.
While one hand compresses, use your other hand to
pull up the ends of the wire wicket and bend them
90
 toward center.
6. Tuck the ends of the bent wire wicket under the tab
on the back of the bag hanger.
7. Remove the cardboard from the front of the bags and
hang bags in place.
Manitowoc Ice, Inc.
2110 South 26 Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA 8008093
Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 Rev. 10/03/97