Miele KM 452 - Manual (Page 6)

KM 452
a Spring clips
^ Make the countertop cut-out following
the dimensions given in the
illustration.
^ Remember to maintain a minimum
distance of 2" (50 mm) between the
rear wall and a right or left hand side
wall. See also "Important Safety
Instructions".
b There must be at least 3 3
/
16
" (81mm)
of usable depth on the right side of
the cut out.
^ Seal the cut surfaces with a suitable
sealant to avoid swelling caused by
moisture. The materials used must be
heat resistant.
If, during installation, the seal around
the frame does not sit flush with the
countertop on the corners, the
corner radius max. R4 (
3 /
16
") can be
carefully filed down to fit.
Appliance and cut-out dimensions
6