McIntosh MT10 - Manual (Page 7)

7
Unpacking the Turntable
Unpacking the Turntable
To protect the fine finish of the MT10 Precision Turntable
during the assembly and adjustment process, it is advisable
to prepare a suitable clean working area with a soft, clean
fabric, such as a bed linen or blanket.
It is recommended that the Professionals at your McIn-
tosh Dealer, who are skilled in all aspects of installation
and operation, unpack, assemble, adjust and install the
MT10 Precision Turntable and any associated audio equip-
ment.
CAUTION: To prevent possible damage to the turntable
platter bearing, do not move the MT10 Preci-
sion Turntable with the platter installed.
1. After opening the outer shipping carton, carefully
remove the turntable inner carton (which has two foam
end caps) and the turntable platter/accessory inner car-
ton. Refer to figure 1.
2. Open the turntable inner carton and remove the top
foam pad. Refer to figure 2.
3. Carefully lift up on the sides of the turntable and re-
move it from the turntable inner carton.
4. Open the turntable platter/accessory carton and remove
the the turntable platter. Refer to Figure 3
Outer
Shipping
Carton
Turntable Carton
Turntable Platter/
Accesory Carton
Figure 1
Accessories Box
Figure 3
Turntable Platter
Top foam pad
Turntable
Figure 2
5. Open the accessories box and check to make sure the
following items are inside:
A. McIntosh MCC10 Moving Coil Cartridge.
B. External Power Supply.
C. Tonearm Counter Weight.
D. Turntable Record Clamp.
E. Turntable Bubble Level.
F. Assembly/Adjustment Tools.
G. Cartridge Mounting Hardware.
H. Pair of cloth gloves.
I. Turntable Bearing Oil (full-synthetic).
J. Tone Arm Height Guage (used for MCC10
Cartridge).
K. Protractor.
M. Cloth Dust Cover
N. Turntable Platter Mat.
Note: The Turnable Platter Mat is located in an
album cover and in the Accessory box.
6. Proceed to Assembly of the Turntable starting on the
next page.