MRV Communications EM316E3 - Manual (Page 6)

Fiber Driver
EM316E3 & EM316E3SF
P/N: 1226006-001, REV_L PAGE 6
Features
• E3 conversion between coax media and fiber media
• Supports ITU-T G.703, ITU-T G.823, and HDB3 standards
• Supports Local, Remote and Line Loop back Test
• Up to 100km Transmission on Single Mode or 7km on Multimode Fiber
• Modules can be Inserted / Removed without powering off the chassis
• Extensive Network Management Support when used with EM316NM
*For dB budget see:
ftp://ftp.fiberdriver.com/pub/doc/spec/fiberdriver
Requirements for Managed Module
EM316NM Management Firmware version 4.0 or later
For firmware released version go to:
ftp://ftp.fiberdriver.com/pub/software/em316nm
For firmware beta version go to:
ftp://ftp.fiberdriver.com/pub/software/beta/em316nm
MegaVision Network Management version 1.20 or later
Connectivity
Connectors Used
Coax: 75 Ω BNC (2 connectors: 1 for TX, 1 for RX)
Fiber: SC, or SC-APC (for single fiber)
Cable Requirement
Coax: RG58/U (Max Length=900 feet)
Fiber: SC-SC fiber cable, or SC-APC fiber cable (for single fiber)
Port Description
Port# Port Description
Port 1 E3 Coax, Conforms to ITU-T G.703, ITU-T G.823, and HDB3 standards
Port 2 E3 Fiber, Multi-Mode: 1310nm, 0-2km
Multi-Mode: 1310nm, 2-7km
Single Mode: 1310nm, 0-25km
Single Mode: 1310nm, 25-50km
Single Mode: 1550nm, 50-100km