Memorex MT0501 - Manual (Page 7)

6
TV OPERATION
TO VIEW A CHANNEL
Make sure the EXT/BATT/
CHARGE switch is set properly
(see page 5). Slide the TV/
OFF/RADIO switch to the TV
position to turn the TV on.
1
Tune a desired TV station by
turning the TUNING control ❶ and
adjust the VOLUME control ❷ as
desired.
1
2
3
Slide the BAND switch to the
desired setting:
VL: Channels 2–6
VH
Channels 7–13
UHF Channels 14–83
2
Adjust the rod antenna for best
picture.
4
Slide the TV/OFF/RADIO switch
to the OFF position to turn the TV
off.
6
Adjust picture controls, as
described below, for best picture.
5
PICTURE CONTROLS
V-HOLD:
If the picture moves up and down
or rolls, rotate to adjust the verti-
cal hold.
1
CONTRAST:
If the picture is too strong or too
weak, rotate to adjust the contrast
and clearly define the shades of
blacks, grays and whites.
3
BRIGHTNESS:
If the picture is too light or dark,
rotate to adjust the brightness.
2
NOTES:
•
When you change channels, the telescopic antenna may have to be re-adjusted for best picture.
• If reception is poor, even after adjusting telescopic antenna, use an external antenna. See page 5
for details.
MT0501.OM O/M 8/13/02 10:35 AM Page 6