Motorola DSR470 - Manual (Page 25)

Using Your Remote
DSR470 User Guide 25
If Your Remote Control Cannot Find a Working Three-
Digit Code in the Tables (Scanning)
If you try to program your remote control using the three-digit codes, and the
remote control does not work correctly, you may be able to find a code that works
by using the "scanning" process.
1. Turn on the TV.
2. Press the TV key for at least three seconds or until the LED blinks.
3. The following steps explain how to "scan" through the TV codes
stored in your remote control using the
L
keys. The LED will not be
lit while the L keys are pressed.
- While pointing the remote control at your TV press the
#
arrow key to
scan upward to the next code. Use the
$
arrow key to return to the
previous code.
- If the transmitted code is the correct one, your TV will turn off,
responding as if its POWER key were pressed.
- If your TV does not respond, press the
#
arrow key to try the next
code. When your TV turns on or off as a result of the transmitted code,
you will know that you have found the correct code.
- When you have found the correct code (power to your TV is toggled on
or off), press the ENTER key. This will store the manufacturer’s code.
The LED will then flash rapidly several times and turn off.
NOTE: If your TV is not listed in the tables and/or the codes for your brand are not
accepted by the remote, you will need to use the remote originally manufactured
for your unit.