MTD E762F - Manual (Page 14)

14
Figure 20
AUGER CLUTCH ADJUSTMENT
To adjust the auger clutch, refer to the Final
Adjustments section page 10.
SHIFT ROD ADJUSTMENT
To adjust the shift rod, remove the hairpin clip and
flat washer which secure the ferrule to the shift lever,
beneath the handle panel. Refer to Figure 15. Refer
to the Final Adjustments section.
CARBURETOR ADJUSTMENT
WARNING: If any adjustments are
made to the engine while the engine is
running (e.g. carburetor), keep clear of
all moving parts. Be careful of heated
surfaces and muffler.
Minor carburetor adjustment may be required to
compensate for differences in fuel, temperature,
altitude and load.
Refer to the separate engine manual packed with
your unit for carburetor adjustment information.
SECTION 9: LUBRICATION
WARNING: Disconnect the spark
plug wire and ground against the
engine before performing any
lubrication or maintenance.
AUGER SHAFT
At least once a season, remove shear bolts on auger
shaft. Oil or spray lubricant inside shaft. See Figure
21. Also lubricate the plastic bearings at least once a
season.
Figure 21
ENGINE
Refer to engine manual for all engine lubrication
instructions.
AXLE BEARINGS
Oil or spray lubricant into axle bearings at the
housing at least once a season.
SPROCKET SHAFT
Lubricate the sprocket shaft with good all-weather
multi-purpose light grease at least once a season or
after every 25 hours of operation.
IMPORTANT: Keep all grease and oil off of the
rubber friction wheel and aluminum drive plate.
DRIVE AND SHIFTING MECHANISM
At least once a season or after every 25 hours of
operation, remove rear cover. Lubricate any chains,
sprockets, gears, bearings, shafts, and shifting
mechanism at least once a season. Use engine oil
or a spray lubricant. Avoid getting oil on rubber
friction wheel and aluminum drive plate. Refer to
Figure 20.
Drive Shaft
Sprocket
Shaft
Drive
Cable
Pivot
Rod
Friction
Plate
Friction
Wheel
Plastic Bearings
Shear Bolts