MTD 3AA & 3CA - Manual (Page 6)

6
IMPORTANT: This unit is shipped with the engine full of
oil. After assembly, see Operation section for fuel and
oil details.
Before Assembly
WARNING: Disconnect the spark plug
wire and Ground it against the engine to
prevent unintended starting.
NOTE: Reference to right, left, front, or rear of the unit is
from the operating position unless otherwise stated.
1. Cut the cable tie that secures the upper handle to
the chute assembly for shipping purposes.
Setting Up The Handle
1. Loosen the chute knob on the upper chute(1) and
pivot the upper chute upwards(2) as far as it will go.
See Figure 1.
WARNING: Do not lift the snow thrower by
the chute handle.
2. Loosen the handle knob and handle tab on each
side of the handle. See Figure 2.
3. Hold both controls against upper handle and pull up
as shown in Step 1 of Figure 3. Make sure that the
upper handle locks over the lower handle and handle
tabs align with the handle. You may have to carefully
maneuver the upper handle to clear chute assembly.
CAUTION: Be careful not to bend or kink the cable.
4. Tighten the handle knobs on each side of the
handle. Refer to Step 2 in Figure 3.
5. Adjust upper chute and rotate chute handle to
desired operating position.
6. Tighten the chute knob on the upper chute making
sure the carriage bolt is correctly positioned. Refer to
Figure 1.
Clean-Out Tool
This tool and the electric extension cord, if so equipped,
may be fastened with a cable tie to the rear of the auger
housing for shipping purposes. In that case, cut the
cable tie and remove the extension cord now.
Final Adjustments
IMPORTANT: Check the adjustments as instructed and
make any final adjustments necessary before operating
the unit. Check all nuts and bolts for tightness. Failure to
follow these instructions may cause damage to unit.
Tire Pressure
The proper inflation pressure is 20 psi. Check the tire
pressure periodically and maintain equal pressure in both
tires at all times. Excessive pressure (well above 20 psi)
may cause the wheel (tire/rim) assembly to burst with
sufficient force to cause serious injury. Do not over-inflate
the tire. Use a manual pump or portable electric tire
inflator to prevent over-inflation. NEVER USE AN AIR
COMPRESSOR.
3
Setup and
Adjustment
Disconnect the spark
plug wire and ground it
against the engine to
prevent unintended
starting.
Do not use the chute
handle to lift the snow
thrower.
Over-inflating the tire with
excessive pressure (well
above 20 psi) may cause
the tire/rim to burst with
sufficient force to cause
serious pressure.
Figure 1
WARNING
Figure 3
Figure 
All references to left
or right side of the snow
thrower is from the
operating position only.
1
2
1
Chute Handle
2
1
Upper
Chute