Motorola SVG2500 - Manual (Page 13)

QUICK INSTALLATION GUIDE 13
Connecting to the Cable Outlet Using a Splitter
Connecting an SVG2500 to the same cable outlet as a TV
requires a 5 to 900 MHz splitter and two additional coaxial
cables. If a coaxial cable is already connecting your TV to the
cable wall outlet, disconnect it from the TV.
1. Connect one end of a coaxial cable to the cable TV wall
outlet and connect the other end to the splitter input.
2. Connect one end of a second coaxial cable to the splitter
output and connect the other end to your TV.
3. Connect one end of a third coaxial cable to the other splitter
output and connect the other end to the cable connector
on your SVG2500.
4. Connect one end of the DC power cord into the power
connector on the SVG2500 and plug the other end into an
AC wall outlet, surge protector, or UPS. This turns the
SVG2500 on.
If, after a few minutes, the POWER, DS, US, and ONLINE lights on
the front panel light solid green, continue with Section B, C, or
D. Otherwise, contact your cable provider and provide your
MAC address.