Edit netcommand®: add devices, continued, Vcr for recordings screen, Rf connection for cable screen – MITSUBISHI ELECTRIC WD-52627 User Manual

Page 51: Ir code for [device] screen

Advertising
background image

Chapter 3. NetCommand Setup and Editing

51

The screens described below may not be necessary for your device setup. If they do not
display automatically on screen, they are not required.

VCR for Recordings Screen

Figure 22

Select the VCR to use for making analog recordings
through NetCommand or the TV Guide On Screen®
system. The VCR inputs must be connected to RECORD
OUT on the TV, which outputs analog signals converted
from digital.

Figure 22. VCR for Recordings screen

Edit NetCommand®: Add Devices, continued

RF Connection for Cable Screen

Figure 23

The RF Connection for Cable screen displays only when

adding or changing a Cable Box. If your Cable Box is
connected to a TV Antenna input, check the RF check
box. Select the TV antenna input that is used with the
Cable Box. Select the channel number used for output
by your cable box from the choices listed (003, 004, 005).
If the Cable Box is also connected to a VCR for recording,
select that VCR.

If your Cable box is connected using Audio/Video or
component cables, make sure the RF check box is
unchecked. Then the next screen will be Connection
(Figure 20), to allow the selection of the TV input used
with the Cable Box.

Figure 23. RF Connection for Cable screen

IR Code for [Device] Screen

Figure 24

This screen only displays if an added device has the

same IR code as a previously added device of the same
type and manufacturer. You can specify the IR setting for
the new device. For example, for the second Mitsubishi

VCR you can specify the IR Code setting to VCR-B, if the

primary Mitsubishi VCR is using the VCR-A IR code.

Figure 24. IR Code for [Device] screen

Advertising
This manual is related to the following products: