M&S Systems 8-Ohm - Manual (Page 8)

Cam-locke mounting tab shown
in the install position (4 places)
Connect to 16
Gauge 2
conductor wire
from wall plate
l
Figure 1
Step 5. Divide each adhesive bead strip in half.
(Adhesive bead strips are in the clear self-closing bag).
Place strips on the edge of the grill as shown in Figure
2. Reinstall the grill on the speaker.
Step 6. Follow the instructions included with the vol-
ume control and amplifier to complete the installation.
SPEAKER INSTALLATION FOR EXISTING
CONSTRUCTION
For existing construction, use the same guidelines for
new construction with the following precautions. It is
very important to determine what is behind the wall
space that you will open when installing the speakers.
Check for standard stud spacing (16” on center pre-
ferred) so you will not need to cut studs and check the
wiring path to the volume control and amplifier. Avoid
120V wiring and air return duct and pipe. Proper
speaker spacing is also critical to a good system.
Page 7