Mamiya 645 AFD III - Manual (Page 54)

105 106
When Any of These Displays Appear
The camera caution mark will blink when the dark slide has not been pulled out,
no film is present, or when the camera detects an abnormality.
* When all frames have been exposed in the ÒCÓ (continuous winding) mode, this indicator will blink
for three seconds.
* When operating with multiple exposures and in shutter release ÒCÓ mode (continuous winding
mode), if you keep pressing the shutter release button, and after completing the set number of
multiple exposure, this indicator appears for 3 seconds and cancels the multiple exposure mode.
* When there are no frames left on the film and the camera has completed winding of the film, this
indicator appears.
* When a roll of film is not loaded, this indicator appears.
* When a roll of film is not rewound properly, this indicator appears.
* If the camera cannot focus in the AF ÒSÓ (Single) mode, you cannot release the shutter.
* When an M645 lens is installed and the aperture is less than f/5.6, this indicator appears.
* This indicator appears when the batterycapacityis low.
* This indicator will appear and auto-bracketing will be deactivated, when you try to perform auto-
bracketing with less than three frame remaining in the ÒCÓ (continuous winding) mode.
* When the film magazine is removed in the multiple exposure mode, this indicator will appear and
the camera will cancel the multiple exposure mode.
However, the magazine does not exit from multiple-exposure mode.
* The shutter will not operate when the dark slide is inserted into the magazine. If you try to press
the shutter release button, this indicator will appear.
* The shutter will not operated when the magazine is not installed onto the camera body. If you try
to press the shutter, this indicator appears.
* This symbol appears when setting the custom functions but you have not selected user A, B, or C.
* While in manual exposure mode, and when the difference between the set value and metered
value exceeds 6EV, this indicator will appear.
* This will appear when a lens is not installed.
* When an M645 lens is installed.
When ÒErrÓ appears, some abnormalityhas been detected in the course of taking photos.
- Take out the film and the ÒEndÓ indicator will disappear.
- Install a roll of film into the camera.
- Press the shutter release button and emergencyfilm winding button simultaneously.
- Tryto adjust focus again, or change to the focus lock mode or manual focus mode.
- Make the lens aperture faster than f/5.6.
- Replace with new batteries.
- Continue to shoot in the multiple-exposure mode, or pull the dark slide and simultaneouslypress the film winding
button and shutter release button.
- Remove the dark slide from the film back.
- Install the film back onto the camera body.
- Select a user before changing the custom function settings.
- Change aperture or shutter speed.
- Install a lens on the camera body.
- Replace with new batteries and press the shutter release button. If the ÒEndÓ indicator still does not disappear, put the
dark slide into the magazine. While pressing the film-rewinding button, half press the shutter release button to rewind
and take out the film. Then contact our sales office or service center.
LCD display
Main
LCD
panel
Viewfinder
LCD read-
outs
Magazine
LCD Problems
Causes and remedies
Remedies
Ref.
page
39
71
39
32
40
37
47
12
69
72
32
91
58,62,66
101
104