Miele K 9412 I EN - Manual (Page 44)

Securing the appliance and
fitting the furniture door
^ Push the appliance against the
housing wall on the side on which the
door opens so that the sealing strip is
pressed into the housing wall h.
^ Secure the appliance at the top with
screw i (4 x 19 mm) into bracket b,
pushing the appliance against the
furniture wall as you do so. Then
secure it at the bottom with screws j
(4 x 36 mm) through the adjusting
screws in the hinge plates to the
housing.
^ Tighten all the screws.
^ If necessary, align cover strip k by
pushing it parallel to the top of the
unit - it should not protrude.
^ Fold in the side section of bracket b.
^ Replace cover a, and cap all the
holes with stoppers l and m.
^ Secure door fixings n to the
appliance door with screw o
(3.9 x 9.5 mm), to suit the position of
the handle,
Very large doors will require several
door fixings.
^ Open the door right out, and push
fixing guides p into door fixings n.
^ Position the furniture door onto the
appliance door, and secure fixing
guides p to the furniture door using
screws q (4 x 14 mm). Maintain a
distance d (= the thickness of the
housing unit walls) between the edge
of the appliance door and outer edge
of the furniture door.
^ Align the door fixing so that the
furniture door on the side with the
handle does not lie against the
housing unit wall when the door is
shut. A minimum distance of 1 mm
r must be maintained. This is vital
for the longterm effectiveness of the
insulation.
Building in the appliance
44