Middleby Marshall Model PS536 - Manual (Page 9)

9
ENGLISH
SECTION 2 - INSTALLATION
III. ASSEMBLY
A. Base Pad Assembly
1. Install the four leg extensions onto the base pad using the
3/8"-16x1" screws, 3/8" flat washers, and 3/8" lockwashers
supplied in the Base Pad Kit. See Figure 2-3. Check that
the finished sides of each leg extension face OUTWARDS.
2. If desired, position the optional lower shelf in place as
shown in Figure 2-3. Check that the lip on the shelf faces
DOWN. The shelf is available separately, and is NOT
included with the Installation Kit.
3. The Installation Kit includes four casters AND four 152mm
adjustable legs. The casters are provided to allow the oven
to be more easily moved to the installation location, and are
NOT suitable for use as part of the oven installation. Refer
to the notice at the beginning of this Section.
•
If the oven is already at the installation location, install
one 152mm adjustable leg into the center hole on the
bottom of each leg extension, as shown in Figure 2-4.
• If it is necessary to move the oven to the installation
location, TEMPORARILY install the casters using the
remaining 3/8"-16x1" screws, 3/8" flat washers, and 3/
8" lockwashers. Move the oven to its final location, and
remove the casters. Then, install the 152mm adjustable
legs as described in the previous step. The threaded
studs on the adjustable legs extend through the lower
shelf and into the leg extensions. This holds the lower
shelf firmly in place.
4. Install the lower oven cavity onto the base pad. See Figure
2-4.
5. For single ovens ONLY, install the top panel using the screws
included in the base pad kit, as shown in Figure 2-5. Then,
skip ahead to Part C, Conveyor Installation.
For double or triple ovens, continue on to Part B, Stacking.
Note that the top panel should NOT be installed for double
and triple ovens until after stacking the oven cavities.
Figure 2-3 - Leg extension and casters installation
152mm adjustable
leg MUST be used
for installation
3/8" flat
washer
3/8" lock
washer
3/8"-16 x 1"
hex screw
Finished sides of
leg extension
face corner of
base pad
Lower
shelf
Figure 2-4 - Base pad installation
#10 x 1" screws
attach front of
top panel
#10 x 2" screws
attach rear of
top panel
Bottom oven
cavity
Assembled
base pad
Top
panel
Figure 2-5 - Top panel installation
NOTE: DO NOT install top panel onto double or triple ovens
until AFTER stacking the oven cavities. See Part B, Stacking.