Motorola SBV5120 - Manual (Page 14)

9 SBV5120 Series VoIP Cable Modem User Guide
Home
X
Exit Print
Introduction Installation Troubleshooting Glossary License
9 To connect the telephone line, plug a phone wire into the Tel 1 connector. You can also connect a second
telephone line to the Tel 2 connector.
Setting Up a USB Driver
The following subsections describe setting up a USB driver. Perform the appropriate procedure for your Windows
version:
•
“Setting Up a USB Driver in Windows 98” on page 10
•
“Setting Up a USB Driver in Windows 2000” on page 15
•
“Setting Up a USB Driver in Windows Me” on page 14
•
“Setting Up a USB Driver in Windows XP” on page 18
When you finish setting up the USB driver, you can continue with “Configuring TCP/IP” on page 19.
The SURFboard VoIP cable modem USB driver does not support Macintosh or UNIX computers. For those
systems connect through Ethernet only.
Caution
Contact your cable service provider before connecting your VoIP cable
modem to your existing telephone wiring. Do not connect the telephone
wire to a traditional telephone (
PSTN ) service.
Be sure the phone connectors are neither connected together nor
connected to wall jacks on the same network.
Be sure the SURFboard VoIP Cable Modem
CD-ROM is inserted in your CD-ROM drive
before you plug in the USB cable.