MegaTech Whirlwind 3000 - Manual (Page 12)

12
PROBLEM CAUSE SOLUTION
No green light on
transmitter when charging
or Whirlwind 3000 will not
charge Power switch on the Whirlwind
3000 and/or the transmitter is
not in the correct position for
charging Set the Transmitter power switch
to “ON” and then make sure the
Whirlwind 3000 power switch is
set to “OFF”. Plug the charge cord
into the Whirlwind 3000 and the
green LED on the transmitter will
come on.
Charger Cord is not properly
plugged into the Whirlwind 3000
charge port Check Charger Cord’s connection
Whirlwind 3000 is not flying
high enough You are not using good throttle
control Increase throttle speed to allow
the Whirlwind 3000 to gain
altitude or for the helicopter to
fly at a desired altitude.
Whirlwind 3000 crashed into
the ground while landing You may have used to much tail
rotor control stick input Reduce the amount of tail rotor
control stick input. Only use very
little input to keep the Whirlwind
3000 level and stable when
landing.
You may have reduced the
throttle speed too quickly or too
much Lower the throttle speed more
gradually to allow the Whirlwind
3000 to land softly.