Metz MZ-1i - Manual (Page 24)

43
12. Working with user programs
If, for example, the operating mode is changed after a stored program has been
called, the LC display switches to „Prog.0“. But the unchanged parameters of the
previously loaded program place are retained.
The factory-set flash programs can be overwritten if you wish to store your own
flash programs. Five stickers, included with the flashgun, can be inscribed as a
memo when storing your own program places.
Procedure for storing a program:
• Select the required settings (aperture, zoom, operating mode, etc.) for sub-
sequent application.
• Press the Prog. button
ቩ; Prog. flashes.
• Use the „+“ or „-“ button
ቪ to select the program place Prog. ? where the set-
tings are to be stored.
• Hold the Remote (STO) key
ብ for abt. 3 seconds depressed until the STO and
RCL symbols go out. The settings are stored after the STO and RCL symbols
have gone out.
The last settings made on program place 0 are retained when the
flashgun is switched off. These settings are reactivated when the
flashgun is switched on again, provided that the batteries were not
removed from the flashgun.
42
☞
13. The zoom reflector
The zoom reflector (main reflector)
The camera can automatically adjust the zoom reflector
ᕡ to the focal length of
the lens; alternatively, this can also be done manually with the Zoom button
ቭ
and the „+“ or „-“ buttons
ቪ.
Zoom 20: Illumination with wide angle diffuser (for 35 mm, from 20 mm focal length onwards)
Zoom 24:Wide-angle illumination (for 35 mm, from 24 mm focal length onwards)
Zoom 28:Wide-angle illumination (for 35 mm, from 28 mm focal length onwards)
Zoom 35:Wide-angle illumination (for 35 mm, from 35 mm focal length onwards)
Zoom 50:Standard illumination (for 35 mm, from 50 mm focal length onwards)
Zoom 70:Telephoto illumination (for 35 mm, from 70 mm focal length onwards)
Zoom 85:Telephoto illumination (for 35 mm, from 85 mm focal length onwards)
Zoom 105:Telephoto illumination (for 35 mm, from 105 mm focal length onwards)
For manual zoom control press the Zoom button
ቭ and adjust the desired zoom
setting with the „+“ or „-“ button
ቪ.
In the event that your camera with SCA adapter automatically transfers the zoom
setting of the lens, simply press the Zoom button
ቭ twice to reactivate automatic
zoom control after a manual zoom reflector adjustment.