MRV Communications HOUSEHOLD MRV AE182FCAHA - Manual (Page 25)

Installation procedure
Installation of remote controller
Installation of the remote controller
1. Remove the back cover of the remote controller
Firstly detach the remote controller back
cover at the bottom, then detach at the top.
The whole back cover of the remote
controller could be removed.
Remote controller bottom
Remote controller back cover
2. Mount the back cover of the remote controller
Drill 3 holes in the wall corresponding to
the positions of 3 screw holes in the back
cover of the remote controller, subseque-
ntly plug a cork into each wall hole. Align
the 3 screw holes in the back cover of the
remote controller with the corks and then
fasten the back cover onto the wall with
wooden screws.
Screw
hole
3. Installing the remote controller
Pull the lead cable of the remote controller
out of the wire hole in the back cover to a
suitable length before fit the remote cont-
roller with the back cover at the bottom,
and then close at the top.
4. Connecting the lead wires
Connect the lead out terminals of the rem-
ote controller with the lead terminals of the
indoor unit using remote controller conne-
cting wire.
PCB
AM
*
*
*
**
24