Digital tuner – Philips AZ 2025 User Manual

Page 11

Advertising
background image

English

DIGITAL TUNER

11

GENERAL INFORMATION

General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,

rain, sand or excessive heat caused by heating equipment or
direct sunlight.

• To clean the set, use a soft, slightly dampened chamois leather.

Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.

Safety information
• Place the set on a hard and flat surface so that the system does

not tilt. Make sure there is adequate ventilation to prevent the
system from overheating.

• The mechanical parts of the set contain self-lubricating bearings

and must not be oiled or lubricated.

TUNING TO RADIO STATIONS

1. Select TUNER source.
™

is displayed briefly and then the radio station frequency is

shown.

2. Press BAND once or more to select your waveband.
3. Press SEARCH

∞ or § (on the remote control,

TUNING

∞ or §) and release when the frequency in the

display starts running.

™ The tuner automatically tunes to a station of sufficient

reception. Display shows

during automatic tuning.

™ If an FM station is received in stereo,

STEREO

is shown.

4. Repeat step 3 if necessary until you find the desired station.
• To tune to a weak station, press SEARCH

∞ or § briefly and

repeatedly until you have found optimal reception.

To improve radio reception
– For FM, pull out the telescopic antenna. Incline and turn the

antenna. Reduce its length if the signal is too strong (very close
to a transmitter).

– For AM, the set is provided with a built-in antenna so the

telescopic antenna is not needed. Direct the antenna by turning
the whole set.

AZ 2025 /17

page

11

ATT

W

XP AZ 2025/17.1 08-05-2000 16:10 Pagina 11

Advertising