Driving, Accelerator position, Stopping – Mercedes-Benz 2002 G-Class User Manual
Page 211
 
208
Automatic transmission
Technical
data
Instruments 
and controls
Operation
Driving
Instrument
cluster display
Practical hints
Car care
Index
Driving
The selector lever is automatically locked while in 
position “P”. To move the selector lever out of 
position “P”, the service brake pedal must be firmly 
depressed before the shift lock will release.
Shift selector lever to the desired position only when the 
engine is idling normally and the service brake is 
applied. Do not release the brake until ready to drive. 
The vehicle may otherwise start creeping when the 
selector lever is in drive or reverse position.
Important!
After selecting any driving position from “N” or “P”, 
wait a moment to allow the gear to fully engage before 
accelerating, especially when the engine is cold.
Accelerator position
Partial throttle = early upshifting = normal acceleration
Full throttle = later upshifting = rapid acceleration
Kickdown (depressing the accelerator beyond full 
throttle) = downshifting to a lower gear = maximum 
acceleration. Once the desired speed is attained, ease up 
on the accelerator – the transmission shifts up again.
Stopping
For brief stops, e.g. at traffic lights, leave the 
transmission in gear and hold vehicle with the service 
brake.
For longer stops with the engine idling, shift into “N” 
or “P” and hold the vehicle with the service brake.
When stopping the vehicle on an uphill gradient, do not 
hold it with the accelerator, use the brake. This avoids 
unnecessary transmission heat build up.
Warning!
It is dangerous to shift the selector lever out of “P” 
or “N” if the engine speed is higher than idle speed. 
If your foot is not firmly on the brake pedal, the 
vehicle could accelerate quickly forward or in 
reverse. You could lose control of the vehicle and 
hit someone or something. Only shift into gear 
when the engine is idling normally and when your 
right foot is firmly on the brake pedal.
On slippery road surfaces, never downshift in order 
to obtain braking action. This could result in drive 
wheel slip and reduced vehicle control. Your 
vehicle’s ABS will not prevent this type of loss of 
control.
J_G463.book Seite 208 Mittwoch, 19. September 2001 8:06 08