Memorex MP8805 - Manual (Page 9)

OPERATION
8
Press the POWER button 1 to turn the unit
on. Press the TUNER/BAND button 2 to
select radio; “TUNE” will appear in the
display.
Repeatedly press the
TUNER/BAND button 2 to select AM or FM.
2
1
1
FM: Press the FM MODE button to turn Stereo
on or off. If a strong stereo station is broadcast-
ing, “STEREO” will appear in the display. Noise
present in FM broadcasts can be reduced by
turning off Stereo.
NOTE: If the station is not broadcast in Stereo or
the broadcast is not strong enough, “STEREO”
will not appear in the display.
4
MANUAL TUNING: Repeatedly rotate
and release the TUNE/SKIP/SEARCH
control towards
o or n to manually
advance the frequency in the display
up or down until the desired frequency
appears.
2
AUTOMATIC TUNING: Gently rotate and
hold the
TUNE/SKIP/SEARCH control
towards o or n until the frequency in the dis-
play starts to scan, and then release the con-
trol; the tuner will search and then stop on the
next strong station it finds. Repeat this step
until the desired frequency appears.
3
Adjust the VOLUME control 1 and EQ
button 2 as desired. Repeatedly press
the EQ button 2 to cycle through the
EQ settings as follows: ROCK, JAZZ,
POP, CLASSIC(AL), (OFF).
2
1
5
To turn the radio off, press the
POWER button again.
6
LISTENING TO THE RADIO
ANTENNAS
AM–This unit has a built-in ferrite rod antenna, which provides adequate reception in most
areas. If reception is weak, turn the unit to improve reception.
FM–The FM Antenna is for FM reception only. If reception is weak, adjust the length and the
angle of the antenna.