A. b, 6 hooking up the tv/vcr – Philips Magnavox CC13B1MG User Manual

Page 6

Advertising
background image

6 Hooking Up the TV/VCR

ANT.

ANT.

Hooking Up Your TV/VCR
With a Cable Signal or
Outdoor Antenna

ANT.

IN

OUT

ANT.

Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT Jack
on the Cable Box and to the
ANT(enna) Jack on the TV/VCR.

Connect a Cable signal
or an antenna to the
ANT(enna) Jack.

Hooking Up Your TV/VCR
With a Cable Box

To view any channel, set the
TV/VCR to the Cable Box output
channel (channel 03 or 04). Then,
select channels at the Cable Box.

1

Hook up your TV/VCR using one of the connections shown.

A.

B.

ANT.

ANT.

Rod Antenna
(not supplied)

Hooking Up Your TV/VCR
With an Indoor Antenna

To install a rod antenna (not sup-
plied), push the stem of the antenna
into the antenna hole on the top of
the TV/VCR. Connect the antenna
wire to the ANT(enna) Jack on the
back of the TV/VCR as shown.
Extend the antenna and adjust its
length, direction, and angle for the
clearest picture.

C.

Connect the Cable signal to
the IN Jack on the Cable Box.

RF coaxial cable

(not supplied)

Advertising
This manual is related to the following products: