Metabo KGS 255 Plus - Manual (Page 25)

25
ENGLISH
Maximum workpiece cross section
(dimensions in mm):
Starting position:
−
Sawhead fully raised.
−
Cutting depth limiter set to maxi-
mum depth of cut.
−
Motorhead in vertical (90°) position,
bevel tilt locking lever tightened.
−
Track arm not extended.
−
Lock screw of the track arm loos-
ened.
Cutting the workpiece:
1. Loosen the lock screw (65) of the
rotating table (63) and disengage
the table lock lever (64).
2. Set to desired angle.
3
Note:
The rotating table engages in
positive stops at the 0°, 15°, 22.5°, 30°
and 45° position.
3. Tighten the rotating table's lock
screw.
4. Cut workpiece as detailed under
"Standard Cross Cuts".
8.3 Bevel Cuts
3 Note:
A bevel cut cuts the workpiece at
an angle other than 90° against its sur-
face.
Maximum workpiece cross section
(dimensions in mm):
Starting position:
−
Sawhead fully raised.
−
Cutting depth limiter set to maxi-
mum depth of cut.
−
Rotating table in 0° position, the lock
screw of the rotating table is tight-
ened.
−
Track arm not extended.
−
Lock screw of the track arm loos-
ened.
Cutting the workpiece:
1. Loosen the ratchet lock lever (66)
for sawhead tilt at the rear of the
saw.
2. Tilt the motorhead slowly into the
desired position.
3. Tighten the sawhead tilt locking
lever.
4. Cut workpiece as described under
"Standard Cross Cuts".
8.4 Compound Mitre Cuts
3
Note:
The compound mitre cut is a
combination of mitre and bevel cut. This
means the workpiece is cut at an angle
other than 90° against the rear guide
edge and against its surface.
A Danger!
When cutting compound
mitres the saw blade is much more
exposed than normally – increased
risk of injury. Always keep sufficient
distance to the saw blade.
Maximum workpiece cross section
(dimensions in mm):
Starting position:
−
Sawhead fully raised.
−
Cutting depth limiter set to maxi-
mum depth of cut.
−
Rotating table locked in desired
position.
−
Sawhead tilted to desired angle
against the workpiece's surface and
locked.
−
Lock screw of the track arm loos-
ened.
−
Track arm not extended.
Cutting the workpiece:
•
Cut workpiece as described under
"Standard Cross Cuts".
8.5 Grooving
3 Note:
Together with the track arm, the
cutting depth limiter makes grooving
Width
approx.
Height
approx.
Rotating table p
o
s
it
io
n
15° 246 60
22.5° 235 60
30° 220 60
45° 177 60
63 64 65
Width
approx.
Height
approx.
Motor head incl
inatio
n
22.5° 255 53
45° 255 30
66
Width with sawhead tilted approx.
22.5° 45°
Rotating table
posi
tio
n
15° 246 246
22.5° 235 235
30° 220 220
45° 177 177
Height with sawhead tilted approx.
22.5° 45°
Rotating
tabl
e
posi
tio
n
15° 53 30
22.5° 53 30
30° 53 30
45° 53 30