Miele DG 2351 - Manual (Page 19)

Before each use
^ When using a perforated cooking
container, push the condensate tray
onto the lowest shelf runner to catch
any drips.
^ Fill the water container.
You do not need to remove the insert.
Only use mains tap water . Never
use distilled or mineral water.
The water level must be between the
two markings (min. 0.75 l and max.
1.2 l). These are located inside and
outside the container. On no account
exceed the upper or maximum level
marker. The amount of water required
will vary depending on what you are
cooking.
Using hot water from a kettle will
shorten the heating-up time.
^ Use both hands to carry the water
container. Take care not to let any
water spill out. Push the water
container into the appliance until it
connects.
If the water container is not positioned
correctly, the appliance will not heat up
and after a while
F20 will appear in the
display (see "Problem solving guide").
Programming steps in brief
To make a selection you turn the
selector, and to confirm your selection
you press it.
The function selector is used to:
A Switch the appliance on by pressing
it
B Select and confirm a cooking
function
The time/temperature selector is
used to:
C Confirm the recommended
temperature or to change it and then
confirm the change
D Select and confirm a cooking
duration
The programme then starts
automatically.
If you do not complete the
programming within 15 minutes, the
appliance will switch itself off.
The cooking functions and
programming steps are described in
more detail on the following pages.
Operation
19