Motorola RDU2080d - Manual (Page 51)

PROG
RAMM
ING
FEAT
URES
English
49
transmitting without having to switch channels
by pressing PTT.
• To stop scanning, short press the SB2 button
again.
• If you press the PTT button while the radio is
scanning, the radio will transmit on the
channel which was selected before you
activated Scan. If no transmission occurs
within five seconds, scanning will resume.
• If you want to scan a channel without
Interference Eliminator Codes (CTCSS/DPL),
set the code settings for the channels to ‘0’ in
the CTCSS/DPL Programming Selection
Mode.
Whenever the radio is set up in ‘Scan Mode’
the LED will signal a fast red blink.
Note: (*) Assumes the SB2 button is not
programmed to other function different from
the default. If Auto-Scan has been enabled
for a particular channel, do not press SB2
button to start scanning, as the radio will do
it automatically.
Programming Scan List
You can enable/disable the Channel Scanning
feature for each channel in your radio. To do
so, enter ’Programming Mode’ and select the
channel you want to program. Scroll through
the programming options by short pressing the
PTT button until you reach the ‘Scan
Programming Mode’. The radio display will
show the scan icon
as follows:
Both the channel number and current scan
setting (YES=ON or NO=OFF) will be blinking
on the display, indicating that you can choose
your setting. To set the channel number, press
the
/ buttons until you reach the desired
channel number.
G
YES