Marantz PD4292D - Manual (Page 31)

25
Basic Operations
POWER
To turn the unit ON and OFF:
1. Plug the power cord into an active AC power outlet.
2. Press the POWER ON button (on the remote control-
ler) to turn on.
The monitor’s POWER/STANDBY indicator will light
up(green) when the unit is on.
3. Press the POWER OFF button (on the remote control-
ler or the unit) to turn off.
The monitor’s POWER/STANDBY indicator turns red
and the standby mode is set (only when turning off the
unit with the remote control).
VOLUME
To adjust the volume:
1. Press and hold the VOLUME ▲ button (on the remote
controller or the unit) to increase to the desired level.
2. Press and hold the VOLUME ▼ button (on the remote
controller or the unit) to decrease to the desired level.
MUTE
To cancel the sound:
Press the MUTE button on the remote controller to cancel
sound; press again to restore.
DISPLAY
To check the settings:
1. The screen changes each time the OSD button is
pressed.
2. If the button is not pressed for approximately three sec-
onds, the menu turns off.
DIGITAL ZOOM
Digital zoom specifies the picture position and enlarges
the picture.
1. Press the 4-D1(ON) button to display the pointer. ( )
To change the size of the picture:
Press the 2-D1(ZOM+) button and enlarge the pic-
ture.
The pointer will change to resemble a magnifying
glass. ( )
A press of the 2-D2(ZOM-) button will reduce the
picture and return it to its original size.
To change the picture position:
Select the position with the ▲▼ ᮤ ᮣ buttons.
2. Press the 4-D1(ON) button to delete the pointer.
PD4292D-2 00.10.4, 3:11 PM 25