Easytouch 25.pdf, 17 problems and troubleshooting, English – Marmitek EasyTouch35 User Manual
Page 25
25
EASYTOUCH 35
17 Problems and troubleshooting
The remote doesn’t work or looses codes entered
•
Confirm with your original remote that the equipment works correctly
•
Make sure that you have pressed the corresponding mode key of the equipment or
device that you want to control.
•
If the listed code does not work, try the AUTOSEARCH method or enter the next
code of that brand.
•
To find the corresponding code for your equipment use the automatic search.
•
Check that the batteries have the correct polarity position.
•
The programming of the remote requires 4 AAA batteries (new). If the remote looses
codes within a few days/weeks the problem can be solved by using 4 new batteries
from the same brand.
•
If the LED is lit permanently, in general it will be necessary to replace the batteries.
Important:
The ET35 must be used only in the way described in this instruction manual and may not
be used for a purpose not intended.
ENGLISH
easytouch35_manual ok 6/17/03 10:30 AM Page 25