Mazda 2007 6 SPORTS SEDAN - Manual (Page 98)

Black plate (97,1)
To install the net:
1. Fold down the rear seatback (page
2-12).
2. Remove the retainer bar from the rear
seatback position.
3. Insert the retainer bar anchors into the
left side of each rear seatback retainer
(back of the seatback).
Retainer bar
Rear seat
Retainer
4. Slide the retainer bar in the direction
indicated in the figure, and engage the
anchors into the seatback retainers.
Retainer bar
5. Slowly pull out the net in the upward
direction, insert the left and right net
anchors into the ceiling retainers, and
slide them to the position indicated in
the figure.
Net
anchor
Net
To remove the net:
1. Lift the net slightly and disengage the
net anchors from the ceiling retainers.
2. Slowly lower and support the net as it
rolls up into the retainer bar.
3. Remove the retainer bar in the reverse
order of installation.
CAUTION
When disengaging the net anchors, hold
the top of the net firmly in your hand. If
you lose control of the net, it will
automatically roll up in an uncontrolled
manner and could cause injury.
Knowing Your Mazda
Doors and Locks
3-19
Mazda6_8W54-EA-06G_Edition1 Page97
Tuesday, July 25 2006 1:52 PM
Form No.8W54-EA-06G