Grounding nport 5400 -4, Connecting to the network -4, Connecting to a serial device -4 – Moxa Technologies 5400 User Manual
Page 12: Led indicators -4, Grounding nport 5400, Connecting to the network, Connecting to a serial device, Led indicators
Grounding NPort 5400
Grounding and wire routing helps limit the effects of noise due to electromagnetic interference (EMI).
Run the ground connection from the ground screw to the grounding surface prior to connecting
devices.
This product is intended to be mounted to a well-grounded mounting surface such as a metal panel.
SG: The Shielded Ground (sometimes called Protected Ground)
contact is the left most contact of the 3-pin power terminal block
connector when viewed from the angle shown here. Connect the
SG wire to an appropriate grounded metal surface.
Connecting to the Network
Connect one end of the Ethernet cable to NPort 5400’s 10/100M Ethernet port and the other end of the
cable to the Ethernet network. If the cable is properly connected, NPort 5400 will indicate a valid
connection to the Ethernet in the following ways:
The Ethernet LED maintains a solid green color when connected to a 100 Mbps Ethernet network.
The Ethernet LED maintains a solid yellow color when connected to a 10 Mbps Ethernet network.
The Ethernet LED will flash when Ethernet packets are being transmitted or received.
Connecting to a Serial Device
Connect the serial data cable between NPort 5400 and the serial device.
LED Indicators
The top panels of NPort 5400 have four LED indicators, as described in the following table.
LED Name
LED Color
LED Function
red
Steady on: Power is on and NPort is booting up.
Blinking: Indicates an IP conflict, or DHCP or BOOTP server did
not
respond
properly.
green
Steady on: Power is on and NPort is functioning normally.
Blinking: The NPort has been located by NPort Administrator’s
Location
function
Ready
off
Power is off, or power error condition exists.
orange
10 Mbps Ethernet connection.
green
100 Mbps Ethernet connection.
Ethernet
off
Ethernet cable is disconnected, or has a short.
orange
Serial port is receiving data.
green
Serial port is transmitting data.
P1, P2,
P3, P4
off
No data is being transmitted or received through the serial port.
NPort 5400 Series User’s Manual
2-4