Miele TOUCHTRONIC T 9802 - Manual (Page 33)

Rear view
a Handle for transportation (arrows)
b Power cord with plug
c Shaft for module
d Air intake
e Vent connection
Stand
A stand with a drawer can be
purchased as an optional accessory.
Installation site
,
Do not install the dryer in a
location where its door could conflict
with room doors.
,
The dryer lid cannot be
removed.
,
The dryer must not be built
under a countertop.
,
If the appliance is installed on a
raised platform it must be secured
with retaining clips available from
your dealer or miele.
If installed on a masonry or concrete
base, the base should have a ½"
(13 mm) to 3/4" (19 mm) high rim.
This must be done to prevent the
dryer from vibrating off the base.
Installation
29