Master Appliance Heat Blower - Manual (Page 2)

The Masterflow ® Heat Blower
is a heavy-duty, industrial-
quality heat blower suitable for
continuous duty applications.
It produces a high volume of
hot air for demanding indus-
trial applications. The
adjustable stand features a
keyhole slot for easy equip-
ment mounting and allows the
nozzle capability of rotating
90° (horizontal to vertical).
Your Masterflow ® is equipped
with a thermal fuse which will
protect the element from over-
heating or burn out due to
a nozzle blockage or motor
failure.
Heat blowers are a source
of extremely high tempera-
ture flameless heat (up to
750°/400°C). As with other
products which generate
extremely high tempera-
tures, regardless of your
specific application,
extreme care and caution
should be observed when
using this product.
Therefore, we recommend
that you pay particular
attention to the safety
instructions which we have
provided for your protection.
WARNING: THIS PRODUCT
IS A SOURCE OF VERY
HIGH TEMPERATURE
FLAMELESS HEAT. AS
WITH ANY ELECTRICAL
TOOL, WHEN USING HEAT
TOOLS, ALWAYS FOLLOW
BASIC SAFETY PRECAU-
TIONS, INCLUDING THE
FOLLOWING, TO REDUCE
THE RISK OF FIRE, ELEC-
TRIC SHOCK OR PER-
SONAL INJURY.
1) Read and understand this
instruction manual before
using. Save this manual for
future reference.
WARNING: To reduce the
risk of fire or electric shock,
do not expose heat blow-
ers to rain or moisture.
Store indoors. Connect to
grounded outlet only.
2) Do not use plug adaptors or
remove the ground prong
from the plug. This tool is
equipped with a 3-prong
plug and a 3-wire grounding
system. Connect to prop-
erly grounded outlets only.
3) Use heat blower only on
adequately rated circuits to
avoid overheating of
electrical systems.
4) Masterflow Heat Blowers
can produce up to
750°F/400°C of flameless
2
Description & Introduction
Important Safety Instructions
Specifications
heat out of the nozzle. Do
not direct this hot air stream
at your clothing, hands or
body parts. Do not use as a
hair dryer.
5) Do not touch nozzle open-
ing or nozzle shield until
cool. When in “Hot” mode,
extreme heat is generated
at those areas. Always hold
tool by the handle or use
permanently attached
stand.
6) Run on “Cold” before turn-
ing off. The nozzle and
shield require approxi-
mately 3 minutes to
become cool to the touch.
*Temperature
Model °F °C Volts Amps
AH-301 300 50 120 10.0
AH-302 300 150 220/240 5.2
AH-501 500 260 120 14.0
AH-502 500 260 220/240 7.3
AH-751 750 400 120 18.0
AH-752 750 400 220/240 9.4
*Average temperature measures 1" from nozzle.