MITSUBISHI ELECTRIC WD-52525 - Manual (Page 7)

MODEL: WD-52525 / WD-52725 / WD-52825 / WD-62525 / WD-62725 / WD-62825
Page 7
CABINET DISASSEMBLY (FRONT VIEW)
WD-52525 / WD-62525 / WD-52725 / WD-62725
Front Cabinet Disassembly
1. Remove the SPEAKER-GRILLE by pulling forward.
2. Remove screws (a) to remove the COVER-FRONT.
3. Remove screws (b) on the rear of the upper back cover (4 across the top and 3 on each side).
4. Remove the 4 screws (c) holding the bottom of the Screen Assembly.
5. Unplug connector LN from the Control Panel.
6. Lift the Screen Assembly up slightly then pull towards the front to remove the assembly.
*Refer to the Parts List for Part Numbers
Reusable Wire Ties
Do not cut wire ties during disassembly, reusable
wire ties are used in these models. Lift the tab to re-
lease the wire tie. During reassembly, re-use wire ties to
ensure all wiring harnesses are properly bundled and
dressed.
Wire Tie
Lift Tab to Release