MITSUBISHI ELECTRIC DLP XD460U - Manual (Page 9)

EN-9
ENGLISH
Using the remote control
30° 30° 30° 30°
20°
10°
20°
10°
20° 20° 20° 20°
Operational range of the remote control
• Keep the remote control photo-sensor out of direct
sunlight or fl uorescent lamp light.
• Keep the remote control photo-sensor at least 2 m
away from fl uorescent lamps. Otherwise, the re-
mote control may malfunction.
• If there is an inverter-operated fl uorescent lamp
near the remote control, the remote control opera-
tion may become unstable.
• When you use the remote control too close to the
remote control sensor, the remote control may not
work correctly.
Reception angle
Vertical directions
Vertical directions (ceiling mount)
Front of projector Rear of projector
Operate the remote
control within a distance
of 10 m from the projector,
pointing the light beam at
the remote control photo-
sensor (front or rear) of
the projector.
When operating the remote control, keep the distance
from the remote control to the projector via the screen
within about 5 m. The operable range of the remote
control, however, depends on the characteristics of the
screen.