Miele KFN 14943 SD ED - Manual (Page 54)

^ Lift the plugs l out of the door
bearing bushing in the appliance
door and place it on the other side.
Mounting the bottom door of the
appliance:
^ Remove the cover a towards the
front.
^ Pull the cover b off.
^ Screw the adjustment foot at the
bearing pin c completely in.
^ With the assistance of another person,
carefully tilt the appliance backwards
and pull the bearing pin c down and
out.
^ Pay attention to the hinge bushing d.
^ Loosen the screws e and remove the
hinge bracket f.
^ Remove the cover g and loosen the
screw. Attach both to the other side.
^ Screw the hinge bracket f onto the
other side with the two outer screws.
Do not use the middle screw; this
allows later alignment of the appliance
door using the outer, elongated holes!
^ Unscrew the bearing part h from the
hinge bracket f, turn it 180° and
screw it into the opposite hole of the
hinge bracket.
^ Now place the cover b on the other
side.
^ With the assistance of another
person, carefully tilt the appliance
backwards and insert the bearing pin
c into the hinge bracket f from
below. The groove in the bottom of
the hinge bracket faces forwards.
^ Place the hinge bushing d onto the
bearing pin c.
^ Put the cover a on.
^ Place the lower door of the appliance
onto the bearing pin c from above.
^ Close the bottom door of the
appliance.
Changing the door hinging
54