Metabo BKS 450 - Manual (Page 4)

Place both support struts onto the table, set
square with the slot of the table insert and bolt
to the table. Use 10 each
countersunk screw M6x16,
hex. nut M6 Install the guard support bracket without fully
tightening the screws.
Use 2 each
countersunk screw M6x16, hex. nut M6,
hex. head screw M8x16,
hex. nut M8 Attach gusset plate with carriage bolt M10x25,
washer 10.5 and starknob M10
Turn saw over and stand onto its legs.
Align and fully tighten all screws. Install legs with struts and diagonal struts to table.
- Tighten all screws handtight only at this stage. - Install struts as shown in drawing “A”.
Hardware: 22 each hex. head bolt M8x16; 4 each hex. head bolt M8x20; 26 each hex. nut M8
Install both hex. head bolts M8x90 into chipca-
se, secure with hex. nuts M8 Re-install saw blade, be sure of correct direc-
tion of rotation. Install chip case lid. Use 2 each
torque type hex. nut M8 Bolt lifting eyes to table (at rear left and front
right). Place pressure spring onto bolt before
screwing on nut. Use 2 each
hex. bolt M8x35
pressure spring 9x20
torque type hex. nut M8
Bolt switch to front support strut. Use 2 each
hex. head bolt M6x16
torque type hex. nut M6 Attach strain relief clamp to support strut. Use
hex. head bolt M6x16
hex. nut M6 Remove saw blade and bolt chip case to both
support struts and motor plate. Hardware:
4 ea. hex head screw M8x16
4 ea. hex. nut M8
2 ea. hex. head bolt M6x16
2 ea. washer 6.4
2 ea. hex. nut M6
90 °
"A"